Light Curing Discoloration 1.2g Pit And Fissure Sealant Pink Color For Decay Teeth

【How to use】
1. Clean the face: install a small brush on the low-speed mobile phone, thoroughly clean the pits and fissures of the face to be sealed, and then use water
Rinse the gun thoroughly. After cleaning the tooth surface, use cotton gauze balls to prevent moisture, and dry the tooth surface and keep it dry.
2. Acid etching, rinsing and drying: It is recommended to use phosphoric acid gel with a phosphoric acid content of not less than 35% for acid etching.
The time is generally 20-30 seconds, and the mammary glands are etched for 60 seconds. Be careful not to wipe the etched surface during the etching process, as this will damage the
Acid-etched stone glaze reduces adhesion.
3. Apply sealant: unscrew the sealing cap of the pit and fissure sealant, install the Denko flushing needle or the Denko delivery head, and gently push the delivery
Apply the pit and fissure sealant directly on the pit and fissure with the push rod of the device. When applying pit and fissure sealant, care should be taken to discharge air bubbles and
The sealant coverage is smaller than the etched side and as thick as possible without compromising the occlusion. sometimes may
High, but wears off after 2-3 days. If the coating is too thin, it will lack sufficient compressive strength and be easily crumbled.
4. Curing: After coating, irradiate the pit and fissure sealant with a light curing machine (lamp) for 20-40 s.
The wavelength should cover 420-480 nm, and the irradiance (light intensity) should not be less than 1000 mw/c㎡, and those with large areas should be irradiated in stages.
This product does not flow after curing, and forms a thin, hard milky white film on the surface of the carcass, which is easy to observe.
5. Inspection: After the sealant is cured, conduct a comprehensive inspection with a probe. Check degree of cure, adhesion, presence of air bubbles
In, look for missing or unsealed fissures and reseal. Observe for excess occlusion material and whether it needs to be removed,
If problems are found, they should be dealt with in time; check the occlusal relationship, and adjust the grinding if the sealant is too thick.